Neusar

AutoC reads and writes ECUC configuration through Neusar. On Settings → Install paths, select the Configurator install root (the folder that contains Bin/ — not Bin itself). The project directory contains *.nccf (or *.neusarprj).

SIP is installed with the Configurator. AutoC picks the version named in the project file; several SIPs may be present under the install.

Open the project and set paths

1. Open a project — pick the folder that contains *.nccf.
2. Settings → Install paths: set the Configurator install root.
3. Settings → Neusar: confirm the project path. When several tools share a module, set the owner under Settings → Module linkage. See Module linkage.
4. Click Save, then Reload.

Success: a Neusar card under Project → Project info. Use Save and Verify on a module. Generate is on the card header and runs for the whole project; it verifies first and skips generate if verification fails. For a module shared by several tools, Save it on the owner's card.

Advanced

Module filters — Include modules / Exclude modules on Settings → Neusar (case-sensitive).

ASW — foreign-reference enums; always scans the open project. See ASW.

Configuration sync

When several tools are used together, choose each module's owner under Settings → Module linkage. Saving the owner writes the shared parameters into the same module on the other tools. See Module linkage.